08 Toyota Tundra Crankshaft Position Sensor Location

Attached to the Crankshaft Position Sensor there are two wires a red one and a green one.

08 toyota tundra crankshaft position sensor location. The two wires were very well protected in a shielded cable blue with a red stripe. When the Tundras ECM determines that there is an issue with the signal coming from this sensor itll throw the P0335 trouble code. I was just wonder how difficult it is to replace the Crankshaft Position Sensor for my 2010 toyota tundra 57L.

P0336 is most commonly caused by a bad crank sensor reluctor ring issue or wiring problems. P0016 is know to occur in the Toyota Tundra when the Crankshaft Position Sensor and the Camshaft Position Sensor are out of alignment by a certain number of. P0345 TOYOTA Description.

Then unplugged it as it was easier to do once out and able to grab. Where is the crankshaft-camshaft sensor bank 2 sensor A located on 57 v8 toyota tundra. I have 2000 Tundra 47 4x4 that wont start.

If anyone has a video or good pic I would appreciate it. It monitors the position and rotational speed of the crankshaft and sends the information to the engine control unit so it can make appropriate adjustments based on operating conditions. Here is the part for the crankshaft position sensor.

I have looked and cant find video of a good pic of where this thing is on the engine. 5 Apr 12 2016. I located it left of the oil pan when on your back looking up.

This sensor uses a reluctor to gauge the position of the crank. Got code for crankshaft position sensor. The camshaft position sensor senses the retraction of camshaft intake to identify a.