08 Toyota Tundra No Ecm Communiation No Start

Follow the procedures in the bulletin to inspect and replace the engine room wire harness as necessary to address customer concerns.

08 toyota tundra no ecm communiation no start. 2011 toyota tundra 57l crank no start. Im having the same issue with my 08 No connection when brought to the inspection station. Died while driving spins ok no start.

I tried using a re-manufactured ECU that was programmed with my VIN I also tried using a junkyard ECU when the re-manufactured unit wouldnt communicate. Car cranks but doesnt start No communication with ECU. I was also wondering if I can fit any ECM that is a 4x4 57 2007-2013 will fit my 2010 DC rw 4x4 57 tundra.

There are certainly many things that could cause an engine not to start though. Try lightly slapping the ECM with your palm and verify that all the wires are plugged in securely into the ECM. Ill recommend to disconnect the cam sensor and check if ecm communication is possible.

Lucky I just did emissions I disconnected the battery two weeks ago in hopes of the CEL would not return however it returned a week later. So I decided to check it with a scanner and found I couldnt communicate with the ECM. I Changed spark plugs coils was cracked battery battery terminals fuel pump but only crank no start.

Fuel is in one line not two. Some 2007 2008 model year Tundra vehicles may exhibit a no start condition with Diagnostic Trouble Code DTC B2799 caused by water intrusion into the engine room wire harness. I dunno where too start and Im afraid toyota if gonna hit me over the head since my warranty is up.

08 tundra wont startno communiction with the ecu. Just a ton of stuff. Toyota tundra 2007 cranks but wont start.