2000 Toyota Tundra Drive Cycle Catalyst

We have driven on freeway about 150 miles.

2000 toyota tundra drive cycle catalyst. You must park the vehicle in a heated garage above 40 F for 12 hours with the key off and fuel tank at 12 to run the evap monitor. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. If you want to get the most out of your vehicle this PaceSetter product is second to none.

Preconditions The monitor will not run unless. Should try that again today also. Reg cabIve been to the tester 4 timeit wont make it thru emissions cause the CATALYST monitor wont get ready.

Ive only drove in D2 with the RPM at around 3000 once. Unplugged the battery for 7 hrs. The smog tech said the monitors are not ready.

Ask Your Own Toyota Question. If there are pending malfunctions that have not yet turned on the malfunction light the monitors will not become ready. I have a 2000 Toyota Tacoma with 250k miles on it that runs like a champ.

Select your 2000 Toyota Tundra requirements and state vehicle registration to buy the best Tundra catalytic converter online that fits your 00 Tundra and meets your state. I let it idle for about 5-10 minutes each time to get it to the TBS pre-conditions. These Monitors are part of the OBDII protocol so that the car can be warmed up and driven to see all of the smog.

Thanks for that information as I had thought the EPA drive cycle was simpler than it turns out to be. Toyota drive cycles for catalyst monitors usually consist of driving the vehicle at highway speed 55-60 mph for about 10 minutes AC off. The catalyst drive cycle from a Toyota bulletin.