2000 Toyota Tundra How To Remove Locked Up Drum Brake

The wheel cylinders unbolt from behind with a 10mm and you will need a 10mm wrench to remove the hard line into it.

2000 toyota tundra how to remove locked up drum brake. Jump to Latest Follow. Make sure that everything is installed in the proper place. I attached the DIY procedure for refurbing the bellcrank.

Remove the rear drum. Its probably a gummed-uplocked-up parking brake bell crank. The sprocket is just intended to back them off to remove the drums if the shoes have worn grooves into them and wont slide off.

If I clamp both front lines off let it sit and still have a good pedal the I likely have a defective new caliper or a bad line. Its not a hard job just a lot of little parts. Tundra Solutions Forum - the best community to.

Sure brakes were ok for a coupe days then started acting up again not as bad as before but still not good. I sell quite a few clean and adjust rear brake jobs. You crawl under behind the brakes and pop out the oval shaped rubber plug on the brake backing plate.

Yes you can adjust them. Same principle as a turkey call. There is a rubber plug on the back side of the backing plate on the top.

Weird thing is is that if i let the car sit for a while more than a few hours or so the car seems to be normal until i drive it again and i get the same problems. 14WA calipers came on 2010 Lexus GX460s and 2015. Removing the drums this often I have no problems with them.