2000 Toyota Tundra Remove Driver Side Door Panel Inside

Direct fit replacement Installation is identical to factory unit.

2000 toyota tundra remove driver side door panel inside. Remove the interior door handle. Discussion Starter 3 Oct 27 2014. Make sure you are holding the window glass or.

Remove the 2 Torx head T30 screws holding the handle to the door frame. You will note that the bent portion points toward the flat tab. There may also be a small nut around the fuse panel.

I have broken into the panel and tried moving the rod attached to the handle up and down but it has no effect. You can see in the photo above the controls have already been removed. You may have to at least lift up the plastic carpet runner that runs along the door cant recall.

Take a screwdriver and remove the screw. I cant remove the panel with the door stuck shut. Remove the felt in the door handle.

Pull the clips out of the back door panel. A safe place for screws so you dont lose them. Trying to unlock it from the outside the key will only turn the lock about halfway.

I have a 2000 Toyota Tundra. Simply open the inside panel roll up the window manually half way up and replace the motor assembly. Move to the bottom of the door and begin to pull the panel out toward you.