2001 Toyota Tundra Drive Cycle

If your smog technician tells you the specific drive cycle to perform you can focus on just triggering that drive cycle.

2001 toyota tundra drive cycle. Toyota has various OBD2 readiness monitors for emissions testing and by conducting a Toyota Drive cycle you can activate and ready the Toyota ODBII sensors. Its a round flat plate with 2 small screws holding it in place. According to customer reports the Tundra can last up to 1000000 miles on the road.

Running through the drive cycle sets all the system monitors so that subsequent faults can be detected. Accelerate back to 55 to 60 mph at ¾ throttle. The following Drive Cycle should set all the required emission monitors.

Repeat steps 1-3 once. OXYGEN SENSOR MONITOR DRIVE CYCLE. Decelerate coast down to a stop without braking.

Repeat steps 1-3 once. Stop the vehicle and idle the engine for 3-5 minutes. The average cost for a Toyota Tundra OBDII drive cycle test is between 44 and 56.

The EVAP Monitor is not required to be complete Ready in order to pass the California smog check. Make sure the ambient temperature is between 40 and 95F. Make sure the gas tank is nearly but not completely full around 34.

The drive cycle that enables a monitor and sets readiness codes to ready varies for each individual monitor. Drive the vehicle at a steady speed between 43 56 mph 70-90 kmh for three to five minutes. A drive cycle is one of the methods used by a vehicles powertrain control module pcm to determine whether an emissions system repair was performed successfully.