2001 Toyota Tundra Knock Sensor Replacement

Or I would really appreciate it if you c.

2001 toyota tundra knock sensor replacement. Start by checking the sensor for tightness. Also replace that coolant hose and the knock sensor harness that live under the intake manifold while you are there. Step by step to replace knock sensors on the block I used all of the information from the pro-demand manual but less steps are needed than stated no need.

2002 Tundra 47L TRD. P0330 is telling you that the ECMPCM is not getting the proper signal from the knock sensor. 2003 Tundra Knock sensor condenser.

Took off intake replaced offending knock sensor and wire soldered into harness reassembled. I replaced both knock sensors and had continuity between the sensors and the PCM. For mthe diy selfers out there the wire is protected by a braided coated wire.

The good news is that it wont cost you an arm and a leg to replace a bad knock sensor. Labor costs are estimated between 234 and 295 while parts are priced at 272. This seemed to make it happy for the last 13000 miles.

This range does not include taxes and fees and does not factor in your specific model year or. 210000 and still going strong. I discovered mice had chewed the wire going to the 1 sensor in two.

KS110 8961522030 Notes. You will have to replace not reuse one gasket between the plenum and the intake manifold and two between the intake manifold and the heads. Check engine light is on and I have the code p0325.