2006 Toyota Tundra Reset Maintenance Light

This is usually done after an oil.

2006 toyota tundra reset maintenance light. Press the Trip button to switch the display to the odometer mileage reading. Turn the key to the on position. If the Tacoma has been driven 5000 miles since the light was reset the light will come on when.

To reset the 2006 Toyota Tundra maintenance light please follow these instructions. Or reset check engine light airbag light inspection key or insp errors when maint reqd for Toyota cars. Turn the key to the on position with the odometer showing.

The MAINT REQ light on my 2006 Toyota stays on even though the oil was changed 2500 miles ago. Press the center button to select. This light warns that the windshield washer fluid level is too low.

Although i do have a 2006 tundra and if your spare. Push and hold the TRIP reset or MODE button. Turn the key onbut dont start itand make sure the odometer is showing the actual mileagenot trip A or BTurn the key back to the off positionthen press and hold the tripreset buttonContinue to hold it down and turn the key to the on positionContinue holding the tripreset button while the mileage flashes rows of zeros until the actual mileage appears againRelease.

Turn the ignition to the RUN position. Turn the key to the off position while still holding the odometer button. Hold ODOTRIP BUTTON For At Least 5 Seconds Until RESETTING MAINTENANCE DATA is.

Once you can see the reading on the Trip Metre A switch off the ignition. Continue holding the trip odometer knob while the ---- symbol flashes on the odometer. Toyota Tundra Oil Maint Required Message Reset Procedure for Model Years 2005-2015.